 |
APPLICATIONS:
The MD-1200 Micro-Drop dispenser provides a cost effective solution when
flood cooling is impractical or unavailable. When used in milling,
tapping, and sawing applications, the MD-1200 dispenses small amounts of
Micro-Drop synthetic or vegetable based lubricant. Compared to flood
cooling, there is no coolant sump to maintain or used coolant to dispose
of.
Solenoid versions allow these units to be interfaced with CNC controls
or other signaling devices. The pressurized delivery system of the
MD-1200, provides instant on/off performance when used with the solenoid
control.
FEATURES:
|
• |
Simple
easy-to-use controls. No confusing timer to set. |
|
• |
Relative
liquid scale allows repeatable set-ups and saves time in
adjusting flow rates for different applications. |
|
• |
Typical
applications use 1 oz. of lubricant in an 8-hour shift. |
|
• |
Positive
pressure design gives instant fluid delivery for faster cycle
times. |
|
• |
The
anti-siphon valves permit the nozzle to be mounted in any
position. |
|
• |
Independent
controls allow for maximum flexibility in adjusting liquid and
air flow for each nozzle. |
|
• |
High
energy nozzle design eliminates fogging for cleaner environment
and greater chip clearing power, allowing faster speed and
feeds. |
|
SPECIFICATIONS:
| System
Type |
Pressure
Delivery, Non-Cyclic |
| Delivery
Lines |
6
ft. Polyurethane |
| Nozzles
|
18"
Loc-Line or 13" Copper |
| Liquid
Flow Range |
2-16
Drops/Minute |
| Liquid
Viscosity |
20-200
SUS |
| Inlet
Air Pressure |
60-125
PSI |
| Recommended
Air Filter |
40
Micron |
| Air
Consumption |
1.7
CFM/Line |
| Air
Inlet Fitting |
1/4
NPT |
| Solenoid
Voltage |
120V
60Hz |
| Dimensions
|
7.06"
H x 10.09" W x 7.06" D |
| Reservoir
Capacity |
16
oz. |
MS-1200 Instructions
MD-1200 Article |
