Lubrication Method Specialists       Home Up Search  

Home
Up

Map to Dean Industrial

 

 

 

 



 


 

 

Hand-Held Filter System

APPLICATIONS:

In the past choices were very limited when it came to filtering lubricants with viscosities greater than 500 SUS @ 100ºF. Now Trico offers a solution with our Hand-Held Filtration Systems. The problem with attempting to filter a high viscosity oil with a lower viscosity system is that the pump and filters are not designed to work with higher pressures required to push high viscosity fluids through the system. As a result these low viscosity units operate primarily in “bypass” mode where little if any of the high-viscosity oil gets filtered.

That is where Trico’s High-Viscosity Gear and Lube Oil Hand-Held System comes in. This system is specifically designed for high-viscosity fluids associated mainly with gear oils and can filter oils up to 7500 SUS @ 100ºF (1600 cSt @ 40ºC).

To ensure that the equipment receives the cleanest oil possible, for increased equipment life, Trico’s Hand-Held Filtration System provides two-stage filtration. The oil flows through the primary filter first, where coarse particulate is removed. Then the fluid flows through the secondary filter where fine particulate and water are removed.

FEATURES:
 
• Differential Pressure Gauges - Indicates when elements need to be changed.
• Oil Sampling Ports - Two sampling ports available to monitor condition of oil.
• Dual Filters - Two-stage filtration for long element life and pump protection.
• Compact Frame - Lightweight design provides flexibility to service equipment located in hard to reach areas.
• Hoses - Heavy-duty PVC.

SPECIFICATIONS:

 Pump Type  Industrial Grade Gear Pump or Pneumatic Motor
 Flow Capacity  1 GPM - Electric
 Pump Speed  1725 RPM - Electric
 Variable up to 3000 RPM - Pneumatic
 Maximum Inlet Vacuum  15" of Mercury
 Hose Sizing @ 2 ft/sec  .75" Diameter Inlet @ 6 feet long
 Max. Operating Temperature  110ºF Continuous
 Pump By-Pass  85 PSI
 Filter By-Pass  43 PSI
 Maximum Viscosity  1600 cSt @ 40ºF / 7500 SUS
 Seal and Gasket Material  Viton®
 Electrical Service Required  115 Volts, 10 Amps, Single Phase, 60 Hz (electric version only)
 Air Inlet Connection  1/4" NPT Female (pneumatic version only)
 Max. Operating Pressure  100 PSI (pneumatic version only)
 Weight  50 lbs - Electric
 49 lbs - Pneumatic
 Dimensions  27"W x 13"D x 17"H 

Hand-Held Filter System Brochure