|
Map to Dean Industrial
| |
PileDriver® III
| Lincoln’s
strive for high quality products can once again been seen with the
PileDriver® III. The Series III motor is fully pneumatic and its reverse
stroke direction without mechanical linkages is simpler and more
reliable that older designs. Also the PileDriver® III pump offers a
choice of inlets for thick material or higher flow rates.
Series III Air Motor
Features
| • |
These fully pneumatic Air Motors reverse stroke direction
without mechanical linkages and are simpler and more reliable
than older designs. |
| • |
Air motors are 3-4-6-8-10 inches (76-101-152-203-254mm)
diameter. |
| • |
An
air Signal Valve activates a Relay Valve at the end of each
stroke. |
| • |
The shifting Relay Valve changes the Power Valve position. |
| • |
The Power Valve shifts air flow to the opposite side of the
Power Piston to reverse stroke direction. |
| • |
Modular Construction: Air Motors are easy to install, maintain,
and upgrade with options like AirBrake®. |
| • |
Built-in Muffler: Meets or exceeds OSHA requirements at
recommended air pressures. |
| • |
AirBrake® Options: Stops runaway pump, prevents product spills, damage
and excess wear, and activates an optional remote alarm device. AirBrake®
available already installed (refer to pump specification charts) or can
be ordered separately as Model 85317. For remote monitoring of AirBrake®,
order model 244398 signal kit. |
|
 |
PileDriver® Series III Pump Tube Features
|
• |
Machined inlet
casting: Set screws secure the inlet assembly and permit 360°
outlet adjustment to facilitate system plumbing and provide for
easy pump removal/replacement. |
|
• |
Cartridge type
gland with scrapers and patented protection bushing: Extends the
life of gland packings by protecting them from excessive
material build up and pressure fluctuations. Cartridge removes easily
for routine service. |
|
• |
Straight
through pump tube and piston port design: Reduces internal
friction and the opportunity for solids entrapment. |
|
• |
Load bearing,
chrome-plated internal pump tube surface: Distributes forces
between gland and pump tube to prolong seal life. |
|
• |
Choice of
inlets: Shovel type for thick material or flat check for higher
flow rates. |
|
 |
PileDriver® III Upgrades
For more than 10 years, PileDriver® III pumps have been recognized as the
leader in diverse, demanding industries such as printing and publishing,
automotive manufacturing and rotational molding. We’ve upgraded them for
improved reliability, ease of use and longer life under the demands of
increasingly tougher pumping applications.
Solutions Vol.5, No.3 |
 |
|
